Changing The Metric Added To Advertised Routes; Displaying Ipv4 Is-Is Information - Dell PowerConnect B-RX Configuration Manual

29

Displaying IPv4 IS-IS information

To change the hello multiplier for Ethernet interface 2/8, enter commands such as the following.
BigIron RX(config)# interface ethernet 2/8
BigIron RX(config-if-e1000-2/8)# isis hello-multiplier 50
This command changes the hello interval to 50. By default, the change applies to both Level-1 and
Level-2.
Syntax: [no] isis hello-multiplier <num> [level-1 | level-2]
The <num> parameter specifies the multiplier, and can be from 3 – 1000. The default is 3.
The level-1 | level-2 parameter applies the change to only the level you specify. If you do not use
this parameter, the change applies to both levels.

Changing the metric added to advertised routes

When the device originates an IS-IS route or calculates a route, the device adds a metric (cost) to
the route. Each IS-IS interface has a separate metric value. The default is 10.
The device applies the interface-level metric to routes originated on the interface and also when
calculating routes. The BigIron RX does not apply the metric to link-state information that the device
receives from one IS and floods to other ISs.
The default interface metric is 10. You can change the metric on an individual interface to a value
in one of the following ranges:
•
•
NOTE
If the metric value you want to use is higher than 63 but you have not changed the metric style to
wide, change the metric style first, then set the metric. The IS-IS neighbors that will receive the
advertisements also must be enabled to receive wide metrics.
To change the IS-IS metric on an interface, use the following CLI method.
BigIron RX(config)# interface ethernet 2/8
BigIron RX(config-if-e1000-2/8)# isis metric 15
Syntax: [no] isis metric <num> [level-1 | level-2]
The <num> parameter specifies the metric. The range of values you can specify depends on the
metric style. You can specify 1 – 63 for the narrow metric style or 1 – 16777215 for the wide metric
style. The default in either case is 10.
The level-1 | level-2 parameter applies the change to only the level you specify. If you do not use
this parameter, the change applies to both levels.
Displaying IPv4 IS-IS information
You can display the following information:
•
•
902
1 – 63 for the narrow metric style (the default metric style for IPv4 ISIS)
1 – 16777215 for the wide metric style (the default metric style for IPv4 ISIS)
The active configuration (the IS-IS commands in the running-config) – refer to
IS-IS configuration in the running-config"
Name mappings – "Displaying the name mappings"
on page 903
on page 903
BigIron RX Series Configuration Guide
"Displaying the
53-1001810-01