Displaying The Active Route Map Configuration - Dell PowerConnect B-RX Configuration Manual

TABLE 127
This field...
Reuse
Path
You also can display all the dampened routes by entering the following command.
show ip bgp dampened-paths.

Displaying the active route map configuration

You can view the device's active route map configuration (contained in the running configuration)
without displaying the entire running configuration.
To display the device's active route map configuration, enter the following command at any level of
the CLI.
BigIron RX# show route-map
route-map permitnet4 permit 10
match ip address prefix-list plist1
route-map permitnet1 permit 1
match ip address prefix-list plist2
route-map setcomm permit 1
set community 1234:2345 no-export
route-map test111 permit 111
match address-filters 11
set community 11:12 no-export
route-map permit1122 permit 12
match ip address 11
route-map permit1122 permit 13
match ip address std_22
This example shows that the running configuration contains six route maps. Notice that the match
and set statements within each route map are listed beneath the command for the route map
itself. In this simplified example, each route map contains only one match or set statement.
To display the active configuration for a specific route map, enter a command such as the following,
which specifies a route map name.
BigIron RX# show route-map setcomm
route-map setcomm permit 1
set community 1234:2345 no-export
This example shows the active configuration for a route map called "setcomm".
Syntax: show route-map [<map-name>]
Graceful restart in BGP
Under normal operation, restarting a BGP router causes the network to be reconfigured. In this
situation, routes available through the restarting router are first deleted when the router goes down
and are then rediscovered and re-added to the routing tables when the router is back up and
running. In a network where routers are restarted regularly, this can degrade performance
BigIron RX Series Configuration Guide
53-1001810-01
Route flap dampening statistics
Displays...
The amount of time remaining until this route will be un-suppressed and
thus be usable again.
Shows the AS-path information for the route.
Displaying BGP4 information
26
849