Displaying Lsp Database Entries - Dell PowerConnect B-RX Configuration Manual

You may enter ip-address <subnet-mask> or ip-address/prefix if you want information for a specific
route.
For example:
BigIron RX# show isis routes 1.0.111.0 255.255.255.0
1.0.111.0
Path: 1
This display shows the following information.
TABLE 134
This field...
Total number of IS-IS routes
Destination
Mask
Cost
Type
Tag
Path
Next Hop IP
Interface
Flags

Displaying LSP database entries

Use the following methods to display summary or detailed information about the entries in the LSP
database.
NOTE
The BigIron RX maintains separate LSP databases for Level-1 LSPs and Level-2 LSPs.
BigIron RX Series Configuration Guide
53-1001810-01
255.255.255.0
Next Hop IP: 4.1.1.1
IS-IS route information
Displays...
The total number of routes in the BigIron RX's IS-IS route table. The total
includes Level-1 and Level-2 routes.
The IP destination of the route.
The subnet mask for the destination address.
The IS-IS default metric for the route, which is the cost of using this route
to reach the next-hop router to this destination.
The route type, which can be one of the following:
•
•
The tag value associated with the route.
The path number in the table. The IS-IS route table can contain multiple
equal-cost paths to the same destination, in which case the paths are
numbered consecutively. When IP load sharing is enabled, the BigIron
RX can load balance traffic to the destination across the multiple paths.
The IP address of the next-hop interface to the destination.
The BigIron RX interface (port or virtual interface) attached to the next
hop.
Values used by Brocade technical support for troubleshooting.
Displaying IPv4 IS-IS information
21 L2 00000000 00000242
Interface: 7/1
L1 – Level-1 route
L2 – Level-2 route
29
909