Displaying information about the ports in an 802.1x multiple client configuration
To display information about the ports in an 802.1x multiple client configuration, enter the
following command.
BigIron RX# show dot1x mac-session brief
Port
---------+----------+----------+-----+-------+-----------+--------
1/1
1/2
1/3
1/4
1/5
Syntax: show dot1x mac-session brief [ | begin <expression> | exclude <expression> | include
The following table describes the information displayed by the show dot1x mac-session brief
command.
TABLE 156
This field...
Port
Number of users
Dynamic VLAN
Dynamic ACL
Dynamic MAC Filters
Sample 802.1x configurations
This section illustrates a sample point-to-point configuration and a sample hub configuration that
use 802.1x port security.
BigIron RX Series Configuration Guide
53-1001810-01
Number of users
Restricted Authorized Total VLAN
0
0
0
0
0
<expression>]
Output from the show dot1x mac-session brief command
Sample 802.1x configurations
Dynamic Dynamic
ACL(In/Out) MAC-Filt
0
1 no
no/no
1
1 yes
yes/no
1
1 yes
yes/no
1
1 yes
yes/no
1
1 yes
yes/no
Displays...
Information about the users connected to each port.
The number of restricted and authorized (those that were successfully
authenticated) users connected to the port.
Whether or not the port is a member of a RADIUS-specified VLAN.
Whether or not a RADIUS-specified ACL has been applied to the port for
incoming (in) and outgoing (out) traffic.
Whether or not a RADIUS-specified MAC Filter has been applied to the
port.
33
Dynamic
no
no
no
no
no
979