Displaying Statistics - Dell PowerConnect B-RX Configuration Manual

17
Displaying VRRP and VRRPE information
TABLE 86
This field...
preempt-mode
virtual ip address
backup router <ip-addr> expires in
<time>
next hello sent in <time>
master router <ip-addr> expires in
<time>
track port

Displaying statistics

To display VRRP statistics, enter the following command.
device#show ip vrrp-extended statistics
Global VRRP-Extended statistics
-------------------------------
- received vrrp-extended packets with checksum errors = 0
- received vrrp-extended packets with invalid version number = 0
- received vrrp-extended packets with unknown or inactive vrid = 1480
Interface v10
----------------
VRID 1
- number of transitions to backup state = 1
- number of transitions to master state = 1
- total number of vrrp-extended packets received = 0
. received backup advertisements = 0
. received packets with zero priority = 0
460
CLI display of VRRP or VRRPE detailed information (Continued)
Displays...
Whether the backup preempt mode is enabled.
NOTE: This field does not apply to VRRP Owners.
The virtual IP addresses that this virtual router is backing up.
The IP addresses of Backups that have advertised themselves to this
Master by sending Hello messages.
The <time> value indicates how long before the Backup expires. A
Backup expires if you disable the advertise backup option on the Backup
or the Backup becomes unavailable. Otherwise, the Backup's next Hello
message arrives before the Backup expires. The Hello message resets
the expiration timer.
An expired Backup does not necessarily affect the Master. However, if
you have not disabled the advertise backup option on the Backup, then
the expiration may indicate a problem with the Backup.
NOTE: This field applies only when Hello messages are enabled on the
How long until the Backup sends its next Hello message.
NOTE: This field applies only when this device is the Master and the
The IP address of the Master and the amount of time until the Master's
dead interval expires. If the Backup does not receive a Hello message
from the Master by the time the interval expires, either the IP address
listed for the Master will change to the IP address of the new Master, or
this device itself will become the Master.
NOTE: This field applies only when this device is a Backup.
The interfaces that the virtual router's interface is tracking. If the link for
a tracked interface goes down, the VRRP or VRRPE priority of the virtual
router interface is changed, causing the devices to renegotiate for
Master.
NOTE: This field is displayed only if track interfaces are configured for
Backups (using the advertise backup option).
Backup is configured to send Hello messages (the advertise
backup option is enabled).
this virtual router.
BigIron RX Series Configuration Guide
53-1001810-01