Configuring Multicast Traffic Engineering - Dell PowerConnect B-RX Configuration Manual

18

Configuring multicast traffic engineering

Displaying the scheduler configuration
To view a Scheduler configuration, use the following command.
BigIron RX#show qos scheduler
Port
-------+-------------------------------------+---------+---------+---------
13/1
13/2
13/3
13/4
13/5
13/6
13/7
13/8
13/9
13/10
13/11
13/12
13/13
13/14
13/15
13/16
13/17
13/18
13/19
13/20
13/21
13/22
13/23
13/24
Syntax: show qos scheduler
Configuring multicast traffic engineering
Using the multicast traffic engineering feature, you can limit the amount of multicast traffic that
passes through a packet processor. This command is configured on an individual port but applies
to all ports connected to the same packet processor.
NOTE
If a user configures any one port between 1-12 (or 13 - 24) with a 'qos multicast best-effort rate of
1Mbps', no more then 1Mbps of multicast traffic will be forwarded at one time on ports 1-12 or
(13-24).
Starting release 02.5.00, data-plane multicast traffic is rate-limited to 1.8 Gbps per packet
processor.
486
| Scheduler
| (Rates where specified are in Kbps)
| strict
| enhanced-strict
| min-rate
| strict
| strict
| max-rate
| destination-weighted
| strict
| source-weighted
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
| strict
Type Prio0 Prio1
Rate 100000 200000
Rate 102400 204800
Rate 400000 400000
Weight 15 25
Weight 5 15
Prio2 Prio3
300000 Remaining
307200 409600
800000 10000000
25 35
35 45
BigIron RX Series Configuration Guide
53-1001810-01