Displaying Route Information - Dell PowerConnect B-RX Configuration Manual

29
Displaying IPv4 IS-IS information
TABLE 133
This field...
Level-2 Designated IS
Level-2 DIS Changes
Next IS-IS LAN Level-1 Hello
Next IS-IS LAN Level-2 Hello
Number of active Level-1 adjacencies
Number of active Level-2 adjacencies
Circuit State Changes
Circuit State Adjacencies Changes
Rejected Adjacencies
Circuit Authentication Fails
Bad LSP
Control Messages Sent
Control Messages Received
IP Enabled

Displaying route information

To display the routes in the BigIron RX's IS-IS route table, use either of the following methods.
To display information about the routes in the BigIron RX's IS-IS route table, enter the following
command at any level of the CLI.
BigIron RX# show isis routes
Total number of IS-IS routes: 173
Destination
1.0.0.0
Path: 1
1.0.0.0
Path: 1
1.0.0.1
Path: 1
1.0.10.0
Path: 1
Syntax: show isis routes [ip-address <subnet-mask> | ip-address/prefix]
908
IS-IS Interface information (Continued)
Displays...
The NET of the Level-2 Designated IS.
The number of times the NET of the Level-2 Designated IS has changed.
Number of seconds before next Level-1 Hello PDU will be transmitted by
the BigIron RX.
Number of seconds before next Level-2 Hello PDU will be transmitted by
the BigIron RX.
The number of ISs with which this interface has an active Level-1
adjacency.
The number of ISs with which this interface has an active Level-2
adjacency.
The number of times the state of the circuit has changed.
The number of times an adjacency has started or ended on this circuit.
The number of adjacency attempts by other ISs rejected by the BigIron
RX.
The number of times the BigIron RX rejected a circuit because the
authentication did not match the authentication configured on the
BigIron RX.
The number of times the interface received a bad LSP from an IS at the
other end of the circuit. The following conditions can cause an LSP to be
bad:
•
•
•
The number of IS-IS control PDUs sent on this interface.
The number of IS-IS control PDUs received on this interface.
If set to TRUE, the IP protocol is enabled for this circuit.
Mask
255.255.255.0
Next Hop IP: 4.1.1.1
255.255.255.255
Next Hop IP: 4.1.1.1
255.255.255.255
Next Hop IP: 4.1.1.1
255.255.255.0
Next Hop IP: 4.1.1.1
Invalid checksum
Invalid length
Invalid lifetime value
Cost Type Tag Flags
21 L2 00000000 00000242
Interface: 7/1
30 L2 00000000 00000242
Interface: 7/1
30 L2 00000000 00000242
Interface: 7/1
30 L2 00000000 00000242
Interface: 7/1
BigIron RX Series Configuration Guide
53-1001810-01