Dell PowerConnect B-RX Configuration Manual page 336

9
Configuring LLDP
By default, the port VLAN ID is automatically advertised when LLDP is enabled on a global basis. To
disable this advertisement, enter a command such as the following.
FastIron(config)#no lldp advertise port-vlan-id ports e 2/4 to 2/12
The untagged VLAN ID will appear similar to the following on the remote device, and in the CLI
display output on the Brocade device (show lldp local-info).
Syntax: [no] lldp advertise port-vlan-id ports ethernet <slotnum/portnum> | all
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and
the configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.
802.3 capabilities
Except for Power-through-MDI information, the Brocade device will advertise the following 802.3
attributes when LLDP is enabled on a global basis:
•
•
•
Link aggregation
The link-aggregation TLV indicates the following:
•
•
•
Brocade devices advertise link aggregation information about standard link aggregation (LACP) as
well as static trunk configuration.
By default, link-aggregation information is automatically advertised when LLDP is enabled on a
global basis. To disable this advertisement, enter a command such as the following.
FastIron(config)#no lldp advertise link-aggregation ports e 2/12
Syntax: [no] lldp advertise link-aggregation ports ethernet <slotnum/portnum> | all
The link aggregation advertisement will appear similar to the following on the remote device, and in
the CLI display output on the Brocade device (show lldp local-info).
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and
the configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.
264
Port VLAN ID: 99
Link aggregation information
MAC/PHY configuration and status
Maximum frame size
Whether the link is capable of being aggregated
Whether the link is currently aggregated
The primary trunk port
Link aggregation: not capable
BigIron RX Series Configuration Guide
53-1001810-01