Clearing The Rip Routes From The Routing Table - Dell PowerConnect B-RX Configuration Manual

TABLE 104
This field...
OSPF metric
Neighbor filter table area
Index
Action
Neighbor IP Address

Clearing the RIP routes from the routing table

Clearing all the routes from the routing table.
To clear RIP local routes, enter a command such as the following.
BigIron(config)#clear ip rip local routes
Syntax: clear ip rip local routes
To clear the RIP routes from the RIP database, enter a command such as the following.
BigIron(config)# clear ip rip routes
Syntax: clear ip rip routes <ip-addr> / <mask-bits>
Use the ip address to specify which routes in the database you want to clear.
Use the subnet mask to specify which subnets you want to clear.
NOTE
Using the clear ip route command will not clear routes learned through RIP.
BigIron RX Series Configuration Guide
53-1001810-01
CLI display of neighbor filter information (Continued)
Displays...
Shows what OSPF route map has been applied.
The filter number. You assign this number when you configure the filter.
The action the router takes for RIP route packets to or from the specified
neighbor:
•
•
The IP address of the RIP neighbor.
deny – If the filter is applied to an interface's outbound filter group,
the filter prevents the router from advertising RIP routes to the
specified neighbor on that interface. If the filter is applied to an
interface's inbound filter group, the filter prevents the router from
receiving RIP updates from the specified neighbor.
permit – If the filter is applied to an interface's outbound filter
group, the filter allows the router to advertise RIP routes to the
specified neighbor on that interface. If the filter is applied to an
interface's inbound filter group, the filter allows the router to
receive RIP updates from the specified neighbor.
Displaying RIP filters
24
673