Modify Virtual Link Parameters - Dell PowerConnect B-RX Configuration Manual

25
Configuring OSPF
The area <ip-addr> | <num> parameter specifies the transit area.
The <router-id> parameter specifies the router ID of the OSPF router at the remote end of the
virtual link. To display the router ID on a BigIron RX, enter the show ip command.
Refer to

Modify virtual link parameters

OSPF has some parameters that you can modify for virtual links. Notice that these are the same
parameters as the ones you can modify for physical interfaces.
You can modify default values for virtual links using the following CLI command at the OSPF router
level of the CLI, as shown in the following syntax.
Syntax: [no] area <num> | <ip-addr> virtual-link <ip-addr> [authentication-key [0 | 1] <string>]
The parameters are described below.
694
<value> |
[md5-authentication key-activation-wait-time <num> | key-id <num> [0 | 1] key <string>]
"Modify virtual link parameters"
[dead-interval <num>]
[hello-interval <num>] [md5-authentication key-activation-wait-time <num> | key-id
<num> [0 | 1] key <string>]
[retransmit-interval <num>] [transmit-delay <num>]
on page 694 for descriptions of the optional parameters.
BigIron RX Series Configuration Guide
53-1001810-01