Displaying A List Of Multicast Groups - Dell PowerConnect B-RX Configuration Manual

23
Anycast RP
This field...
SPT Threshold
PIM Sparse interface information
NOTE: You also can display IP multicast interface information using the show ip pim interface command. However,
Interface
TTL Threshold
Local Address

Displaying a list of multicast groups

To display PIM Sparse configuration information, enter the following command at any CLI level.
BigIron RX(config-pim-router)# show ip pim group
Total number of Groups: 2
Index 1
Syntax: show ip pim group
This display shows the following information.
This field...
Total number of Groups
Index
Group
Ports
612
this command lists all IP multicast interfaces, including regular PIM (dense mode) and DVMRP interfaces.
The show ip pim sparse command lists only the PIM Sparse interfaces.
Group 239.255.162.1
Displays...
The number of packets the device sends using the path through the RP
before switching to using the SPT path.
The type of interface and the interface number. The interface type can
be one of the following:
•
Ethernet
•
VE
The number is either a port number (and slot number if applicable) or
the virtual interface (VE) number.
Following the TTL threshold value, the interface state is listed. The
interface state can be one of the following:
•
Disabled
•
Enabled
Indicates the IP address configured on the port or virtual interface.
Ports e3/11
Displays...
Lists the total number of IP multicast groups the device is forwarding.
NOTE: This list can include groups that are not PIM Sparse groups. If
interfaces on the device are configured for regular PIM (dense
mode) or DVMRP, these groups are listed too.
The index number of the table entry in the display.
The multicast group address
The device ports connected to the receivers of the groups.
BigIron RX Series Configuration Guide
53-1001810-01