Dell PowerConnect B-RX Configuration Manual page 297

TABLE 55
This field...
ICMP statistics
The ICMP statistics are derived from RFC 792, "Internet Control Message Protocol", RFC 950, "Internet Standard
Subnetting Procedure", and RFC 1256, "ICMP Router Discovery Messages". Statistics are organized into Sent and
Received. The field descriptions below apply to each.
total
errors
unreachable
time exceed
parameter
source quench
redirect
echo
echo reply
timestamp
timestamp reply
addr mask
addr mask reply
irdp advertisement
irdp solicitation
UDP statistics
received
sent
no port
input errors
TCP statistics
The TCP statistics are derived from RFC 793, "Transmission Control Protocol".
active opens
passive opens
failed attempts
active resets
passive resets
BigIron RX Series Configuration Guide
53-1001810-01
CLI display of IP traffic statistics (Continued)
Displays...
The total number of ICMP messages sent or received by the device.
This information is used by Brocade customer support.
The number of Destination Unreachable messages sent or received by the
device.
The number of Time Exceeded messages sent or received by the device.
The number of Parameter Problem messages sent or received by the device.
The number of Source Quench messages sent or received by the device.
The number of Redirect messages sent or received by the device.
The number of Echo messages sent or received by the device.
The number of Echo Reply messages sent or received by the device.
The number of Timestamp messages sent or received by the device.
The number of Timestamp Reply messages sent or received by the device.
The number of Address Mask Request messages sent or received by the
device.
The number of Address Mask Replies messages sent or received by the
device.
The number of ICMP Router Discovery Protocol (IRDP) Advertisement
messages sent or received by the device.
The number of IRDP Solicitation messages sent or received by the device.
The number of UDP packets received by the device.
The number of UDP packets sent by the device.
The number of UDP packets dropped because the packet did not contain a
valid UDP port number.
This information is used by Brocade customer support.
The number of TCP connections opened by this device by sending a TCP SYN
to another device.
The number of TCP connections opened by this device in response to
connection requests (TCP SYNs) received from other devices.
This information is used by Brocade customer support.
The number of TCP connections this device reset by sending a TCP RESET
message to the device at the other end of the connection.
The number of TCP connections this device reset because the device at the
other end of the connection sent a TCP RESET message.
Displaying IP information
7
225