Dell PowerConnect B-RX Configuration Manual page 914

26
Displaying BGP4 information
Displaying information for a specific route
To display BGP4 network information by specifying an IP address within the network, enter a
command such as the following at any level of the CLI.
BigIron RX(config-bgp)# show ip bgp 9.3.4.0
Number of BGP Routes matching display condition : 1
Status codes: s suppressed, d damped, h history, * valid, > best, i internal
Origin codes: i - IGP, e - EGP, ? - incomplete
*>
Syntax: show ip bgp [route] <ip-addr>/<prefix> [longer-prefixes] | <ip-addr>
If you use the route option, the display for the information is different, as shown in the following
example.
BigIron RX(config-bgp)# show ip bgp route 9.3.4.0
Number of BGP Routes matching display condition : 1
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
1
These displays show the following information.
TABLE 124
This field...
Number of BGP Routes matching
display condition
Status codes
Prefix
Next Hop
Metric
LocPrf
842
Network Next Hop
9.3.4.0/24 192.168.4.106
Last update to IP routing table: 0h11m38s, 1 paths installed:
Gateway
192.168.2.1
Route is advertised to 1 peers:
20.20.20.2(65300)
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED F:FILTERED
Prefix
9.3.4.0/24
AS_PATH: 65001 4355 1 1221
Last update to IP routing table: 0h12m1s, 1 path(s) installed:
Gateway
192.168.2.1
Route is advertised to 1 peers:
20.20.20.2(65300)
BGP4 network information
Metric LocPrf Weight Path
100
Port
2/1
Next Hop Metric
192.168.4.106
Port
2/1
Displays...
The number of routes that matched the display parameters you entered.
This is the number of routes displayed by the command.
A list of the characters the display uses to indicate the route's status.
The status code appears in the left column of the display, to the left of
each route. The status codes are described in the command's output.
NOTE: This field appears only if you do not enter the route option.
The network address and prefix.
The next-hop router for reaching the network from the BigIron RX.
The value of the route's MED attribute. If the route does not have a
metric, this field is blank.
The degree of preference for this route relative to other routes in the
local AS. When the BGP4 algorithm compares routes on the basis of
local preferences, the route with the higher local preference is chosen.
The preference can have a value from 0 – 4294967295.
0 65001 4355 1 1221 ?
LocPrf Weight Status
100 0 BE
BigIron RX Series Configuration Guide
53-1001810-01