11
Displaying VLAN information
Syntax: [no] uplink-switch ethernet <port-number> [to <port-number> | ethernet <port-number>]
In this example, 24 ports on a 10/100 module and two Gigabit ports on a Gigabit module are
added to port-based VLAN 10. The two Gigabit ports are then configured as uplink ports.
Configuring control protocols in VLANs
You can configure the following protocols on a VLAN:
•
•
•
•
Other configuration options
You can also configure the following on a VLAN:
•
•
Displaying VLAN information
After you configure the VLANs, you can view and verify the configuration.
Displaying VLAN information
Enter the following command at any CLI level.
BigIron RX# show vlan
Configured PORT-VLAN entries: 3
Maximum PORT-VLAN entries: 4095
Default PORT-VLAN id: 1
PORT-VLAN 1, Name DEFAULT-VLAN, Priority Level0
L2 protocols
Untagged Ports : ethe 2/1 to 2/24 ethe 3/1 to 3/24 eth
PORT-VLAN 2, Name [None], Priority Level0
L2 protocols
ip-protocol VLAN, Dynamic port disabled
Name: basic
PORT-VLAN 1001, Name [None], Priority Level0
L2 protocols
Tagged Ports
Syntax: show vlan [<vlan-id>] [| [begin <expression> | exclude <expression> | include
Enter a VLAN ID if you want to display information for a specific VLAN.
314
MRP (Refer to
Chapter 14, "Metro Ring Protocol (MRP) Phase 1 and
VSRP (Refer to
Chapter 15, "Virtual Switch Redundancy Protocol
STP (Refer to
Chapter 12, "Configuring Spanning Tree
RSTP (Refer to
Chapter 13, "Configuring Rapid Spanning Tree
"Configuring static ARP entries"
"Setting maximum frame size per PPCR"
: NONE
: NONE
: MRP
: ethe 3/1 ethe 3/12 to 3/13 ethe 3/24
<expression>]
Protocol".)
on page 132
on page 172
2".)
(VSRP)".)
Protocol".)
BigIron RX Series Configuration Guide
53-1001810-01