Redistributing Connected Routes; Redistributing Rip Routes; Redistributing Ospf External Routes - Dell PowerConnect B-RX Configuration Manual

Redistributing connected routes

To configure BGP4 to redistribute directly connected routes, enter the following command.
BigIron RX(config-bgp)# redistribute connected
Syntax: redistribute connected [metric <num>] [route-map <map-name>]
The connected parameter indicates that you are redistributing routes to directly attached devices
into BGP4.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295.
The default
is not assigned.
The route-map <map-name> parameter specifies a route map to be consulted before adding the
RIP route to the BGP4 route table.
NOTE
The route map you specify must already be configured on the router. Refer to
on page 798 for information about defining route maps.

Redistributing RIP routes

To configure BGP4 to redistribute RIP routes and add a metric of 10 to the redistributed routes,
enter the following command.
BigIron RX(config-bgp)# redistribute rip metric 10
Syntax: redistribute rip [metric <num>] [route-map <map-name>]
The rip parameter indicates that you are redistributing RIP routes into BGP4.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295.
The default
is not assigned.
The route-map <map-name> parameter specifies a route map to be consulted before adding the
RIP route to the BGP4 route table.
NOTE
The route map you specify must already be configured on the router. Refer to
on page 798 for information about defining route maps.

Redistributing OSPF external routes

To configure the BigIron RX to redistribute OSPF external type 1 routes, enter the following
command.
BigIron RX(config-bgp)# redistribute ospf match external1
Syntax: redistribute ospf [match internal | external1 | external2] [metric <num>] [route-map
The ospf parameter indicates that you are redistributing OSPF routes into BGP4.
The match internal | external1 | external2 parameter applies only to OSPF. This parameter
specifies the types of OSPF routes to be redistributed into BGP4. The default is internal.
BigIron RX Series Configuration Guide
53-1001810-01
<map-name>]
Modifying redistribution parameters
"Defining route maps"
"Defining route maps"
26
785