Displaying The Rp Set List; Displaying Multicast Neighbor Information - Dell PowerConnect B-RX Configuration Manual

23
Anycast RP

Displaying the RP set list

To display the RP set list, enter the following command at any CLI level.
BigIron RX(config)#show ip pim rp-set
Group address Static-RP-address Override
---------------------------------------------------
Access-List 44 99.99.99.5 On
Number of group prefixes Learnt from BSR: 1
Group prefix = 239.255.162.0/24 # RPs expected: 1
# RPs received: 1
RP 1: 43.43.43.1 priority=0 age=0
Syntax: show ip pim rp-set
This display shows the following information.
This field...
Number of group prefixes
Group prefix
RPs expected/received
RP <num>
priority
age

Displaying multicast neighbor information

To display information about the device's PIM neighbors, enter the following command at any CLI
level.
BigIron RX(config-pim-router)# show ip pim nbr
Port
e3/8
Port
v1
Syntax: show ip pim nbr
This display shows the following information.
616
Neighbor Holdtime
sec
207.95.8.10 180
Neighbor Holdtime
sec
207.95.6.2 180
Table 0.6:
Displays...
The number f PIM Sparse group prefixes for which the RP is responsible.
Indicates the multicast groups for which the RP listed by the previous
field is a candidate RP.
Indicates how many RPs were expected and received in the latest
Bootstrap message.
Indicates the RP number. If there are multiple RPs in the PIM Sparse
domain, a line of information for each of them is listed, and they are
numbered in ascending numerical order.
The RP priority of the candidate RP. During the election process, the
candidate RP with the highest priority is elected as the RP.
The age (in seconds) of this RP-set.
NOTE: If this device is not a BSR, this field contains zero. Only the BSR
ages the RP-set.
Age UpTime
sec sec
60 900
Age UpTime
sec sec
60 900
BigIron RX Series Configuration Guide
53-1001810-01