Displaying Ip Interface Information - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.7.02
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

TABLE 49
This field...
Destination
Protocol
Port
Operator

Displaying IP interface information

To display IP interface information, enter the following command at any CLI level.
BigIron RX(config)# show ip interface
Interface
Ethernet 1/1
Ethernet 1/2
Loopback 1
Syntax: show ip interface [ethernet <slot/port>] | [loopback <num>] | [ve <num>]
This display shows the following information.
TABLE 50
This field...
Interface
IP-Address
OK?
Method
BigIron RX Series Configuration Guide
53-1001810-01
CLI display of global IP configuration information (Continued)
Displays...
The destination IP address the policy matches.
The IP protocol the policy matches. The protocol can be one of the following:
ICMP
IGMP
IGRP
OSPF
TCP
UDP
The Layer 4 TCP or UDP port the policy checks for in packets. The port can
be displayed by its number or, for port types the router recognizes, by the
well-known name. For example, TCP port 80 can be displayed as HTTP.
NOTE: This field applies only if the IP protocol is TCP or UDP.
The comparison operator for TCP or UDP port names or numbers.
NOTE: This field applies only if the IP protocol is TCP or UDP.
IP-Address
207.95.6.173
3.3.3.3
1.2.3.4
CLI display of interface IP configuration information
Displays...
The type and the slot and port number of the interface.
The IP address of the interface.
NOTE: If an "s" is listed following the address, this is a secondary address.
Whether the IP address has been configured on the interface.
Whether the IP address has been saved in NVRAM. If you have set the IP
address for the interface in the CLI, but have not saved the configuration,
the entry for the interface in the Method field is "manual".
Displaying IP information
OK?
Method
Status
YES
NVRAM
up
YES
manual
up
YES
NVRAM
down
When the address was configured, the interface already had an IP
address in the same subnet, so the software required the
"secondary" option before the software could add the interface.
7
Protocol
up
up
down
215

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brocade dcx-4sBrocade dcx

Table of Contents