Viewing Ipv6 Snmp Server Addresses; Disabling Router Advertisement And Solicitation Messages - Dell PowerConnect B-RX Configuration Manual

Viewing IPv6 SNMP server addresses

Some of the show commands display IPv6 addresses for IPv6 SNMP servers. The following shows
an example output for the show snmp server command.
BigIron RX# show snmp server
Community(ro): .....
Traps
Total Trap-Receiver Entries: 4
Trap-Receiver IP-Address

Disabling router advertisement and solicitation messages

Router advertisement and solicitation messages enable a node on a link to discover the routers on
the same link. By default, router advertisement and solicitation messages are permitted on the
device. To disable these messages, configure an IPv6 access list that denies them. The following
shows an example configuration.
Example
BigIron RX(config)# ipv6 access-list rtradvert
BigIron RX(config)# deny icmp any any router-advertisement
BigIron RX(config)# deny icmp any any router-solicitation
BigIron RX(config)# permit ipv6 any any
BigIron RX Series Configuration Guide
53-1001810-01
Contact:
Location:
Warm/Cold start: Enable
Link up: Enable
Link down: Enable
Authentication: Enable
Locked address violation: Enable
Power supply failure: Enable
Fan failure: Enable
Temperature warning: Enable
STP new root: Enable
STP topology change: Enable
vsrp: Enable
1 192.147.201.100
2 4000::200
3 192.147.202.100
4 3000::200
IPv6 host support
Port-Number Community
162 .....
162 .....
162 .....
162 .....
43
1075