Dell PowerConnect B-RX Configuration Manual page 817

The address family command also requires you to select a sub-address family, which is the type of
routes for the configuration. You specify multicast or unicast routes.
FIGURE 112
Table 26.1 shows what commands are available at the various BGP configuration levels.
TABLE 116
Command
address-family
address-filter
aggregate-address
always-compare-med
as-path-filter
as-path-ignore
bgp-redistribute-internal
client-to-client-reflection
cluster-id
community-filter
compare-routerid
confederation
dampening
default-information-origi
nate
BigIron RX Series Configuration Guide
53-1001810-01
BGP configuration levels
Global commands for BGP
router bgp
and all address families
IPv4 BGP commands at different configuration levels
Global IPv4 address
(iPv4 and family unicast
IPv6)
x x
x
x
x
x
x
x
x
x
x
x
x
x
Configuring BGP4
address-family
IPv6 unicast
Commands for IPv6
BGP unicast routes
address-family
IPv4
IPv4 address See
family
multicast
x "Entering and exiting the address family
configuration level"
"Filtering specific IP addresses"
x "Aggregating routes advertised to BGP4
neighbors" on page 757
"Configuring the BigIron RX to always
compare Multi-Exit Discriminators (MEDs)"
page 757
"Disabling or re-enabling comparison of the
AS-path length"
"Redistributing IBGP routes"
"Disabling or re-enabling client-to-client route
reflection" on page 759
"Configuring a route reflector"
"Enabling or disabling comparison of the
router IDs" on page 759
"Configuring confederations"
x "Configuring route flap dampening"
page 763
x "Originating the default route"
26
multicast
Commands for IPv4
MBGP routes
unicast
Commands for IPv4
BGP unicast routes
on page 749
on page 749
on
on page 758
on page 758
on page 759
on page 760
on
on page 764
745