43
IPv6 host support
Restricting web management access to an IPv6 host by specifying an
IPv6 ACL
You can specify an IPv6 ACL that restricts Web management access to management functions on
the device. For example.
BigIron RX(config)# access-list 12 deny host 2000:2383:e0bb::2/128 log
BigIron RX(config)# access-list 12 deny 30ff:3782::ff89/128 log
BigIron RX(config)# access-list 12 deny 3000:4828::fe19/128 log
BigIron RX(config)# access-list 12 permit any
BigIron RX(config)# web access-group ipv6 12
Syntax: web access-group ipv6 <ipv6 ACL name>
where <ipv6 ACL name> is a valid IPv6 ACL.
Restricting web management access to an IPv6 host
You can restrict Web management access to the device to the IPv6 host whose IP address you
specify. No other device except the one with the specified IPv6 address can access the Brocade
device's Web management interface. For example.
BigIron RX(config)# web client ipv6 3000:2383:e0bb::2/128
Syntax: web client ipv6 <ipv6-address>
The <ipv6-address> you specify must be in hexadecimal format using 16-bit values between colons
as documented in RFC 2373.
Configuring an IPv6 Syslog server
To specify an IPv6 Syslog server, enter a command such as the following.
BigIron RX(config)# log host ipv6 2000:2383:e0bb::4/128
Syntax: log host ipv6 <ipv6-address> [<udp-port-num>]
The <ipv6-address> you specify must be in hexadecimal using 16-bit values between colons as
documented in RFC 2373.
The <udp-port-num> optional parameter specifies the UDP application port used for the Syslog
facility.
1074
BigIron RX Series Configuration Guide
53-1001810-01