Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the following command at any CLI level.
BigIron RX(config-pim-router)# show ip pim rp-map
Number of group-to-RP mappings: 6
Group address
-------------------------------
1 239.255.163.1
2 239.255.163.2
3 239.255.163.3
4 239.255.162.1
5 239.255.162.2
6 239.255.162.3
Syntax: show ip pim rp-map
This display shows the following information.
This field...
Group address
RP address
Displaying RP information for a PIM Sparse group
To display RP information for a PIM Sparse group, enter the following command at any CLI level.
BigIron RX(config-pim-router)# show ip pim rp-hash 239.255.162.1
RP: 207.95.7.1, v2
Syntax: show ip pim rp-hash <group-addr>
The <group-addr> parameter is the address of a PIM Sparse IP multicast group.
This display shows the following information.
This field...
RP
Info source
BigIron RX Series Configuration Guide
53-1001810-01
RP address
99.99.99.5
99.99.99.5
99.99.99.5
99.99.99.5
43.43.43.1
99.99.99.5
Info source: 207.95.7.1, through bootstrap
Table 0.4:
Displays...
Indicates the PIM Sparse multicast group address using the listed RP.
Indicates the IP address of the Rendezvous Point (RP) for the listed PIM
Sparse group.
Table 0.5:
Displays...
Indicates the IP address of the Rendezvous Point (RP) for the specified
PIM Sparse group.
Following the IP address is the port or virtual interface through which
this device learned the identity of the RP.
Indicates the IP address on which the RP information was received.
Following the IP address is the method through which this device
learned the identity of the RP.
23
Anycast RP
615