Displaying Vrrp And Vrrpe Information; Displaying Summary Information - Dell PowerConnect B-RX Configuration Manual

17

Displaying VRRP and VRRPE information

Displaying VRRP and VRRPE information
You can display the following information for VRRP or VRRPE:
•
•
•

Displaying summary information

To display summary information for a device, enter the following command at any level of the CLI.
BigIron RX(config)# show ip vrrp-extended brief
Total number of VRRP-Extended routers defined: 41
Inte- VRID Current
rface
-----------------------------------------------------------------------------
v21
v22
v23
v24
v25
v26
v27
Syntax: show ip vrrp [brief | ethernet <slot>/<portnum> | ve <num> | stat]
Syntax: show ip vrrp-extended [brief | ethernet <slot>/<portnum> | ve <num> | stat]
The brief parameter displays the summary information. If you do not use this parameter, detailed
information is displayed instead. Refer to
The ethernet <slot>/<portnum> parameter specifies an Ethernet port. If you use this parameter,
the command displays VRRP or VRRPE information only for the specified port.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command
displays VRRP or VRRPE information only for the specified virtual interface.
The stat parameter displays statistics. Refer to
This display shows the following information.
TABLE 85
This field...
Total number of VRRP (or
VRRP-Extended) routers defined
Interface
VRID
456
Summary configuration and status information
Detailed configuration and status information
VRRP and VRRPE Statistics
P State
Priority
21 95 P Backup
22 95 P Backup
23 95 P Backup
24 95 P Backup
25 95 P Backup
26 95 P Backup
27 95 P Backup
CLI display of VRRP or VRRPE summary information
Master IP Backup IP
Address Address
172.16.51.2 Local
172.16.52.2 Local
172.16.53.2 Local
172.16.54.2 Local
172.16.55.2 Local
172.16.56.2 Local
172.16.57.2 Local
"Displaying detailed information"
"Displaying statistics"
Displays...
The total number of virtual routers configured on this device.
NOTE: The total applies only to the protocol the device is running. For
example, if the device is running VRRPE, the total applies only to
VRRPE routers.
The interface on which VRRP or VRRPE is configured. If VRRP or VRRPE
is configured on multiple interfaces, information for each interface is
listed separately.
The ID of the virtual router configured on this interface. If multiple
virtual routers are configured on the interface, information for each
virtual router is listed in a separate row.
Virtual IP
Address
172.16.51.1
172.16.52.1
172.16.53.1
172.16.54.1
172.16.55.1
172.16.56.1
172.16.57.1
on page 457.
on page 460.
BigIron RX Series Configuration Guide
53-1001810-01