Configuring Ip Multicast Traffic Reduction - Dell PowerConnect B-RX Configuration Manual

23

Configuring IP multicast traffic reduction

NOTE
Regardless of the administrative distances, the device Series router always prefers directly
connected routes over other routes.
FIGURE 98
PIM Router A
To add a static route to a virtual interface, enter commands such as the following.
BigIron RX(config)# ip mroute 3 0.0.0.0 0.0.0.0 ve 1 distance 1
BigIron RX(config)# write memory
Configuring IP multicast traffic reduction
In Layer 2 mode, device forwards all IP multicast traffic by default based on the Layer 2 information
in the packets. Optionally, you can enable the device to make forwarding decisions in hardware,
based on multicast group by enabling the IP Multicast Traffic Reduction feature.
NOTE
The IP Multicast Traffic Reduction feature is applicable for Layer 2 mode only.
When this feature is enabled, the device examines the MAC address in an IP multicast packet and
forward the packet only on the ports from which the device has received Group Membership
reports for that group, instead of forwarding all multicast traffic to all ports. The device sends traffic
for other groups out all ports.
652
Example multicast static routes
e1/2
207.95.6.2
e2/3
207.95.7.2
e3/11
8.8.8.164
Client
Multicast group
239.255.162.1
Client
Multicast group
239.255.162.1
PIM Router B
e1/4
e1/5
207.95.7.1
207.95.8.10
PIM Router D
9.9.9.101 e6/14
e4/11
207.95.6.1
PIM Router C
e1/8
207.95.8.1
e3/19
209.157.24.62
Server
Multicast group
239.255.162.1
BigIron RX Series Configuration Guide
53-1001810-01