Port Storm-Control Broadcast Enable; Port Storm-Control Broadcast Rate - Planet WGSD-1022 User Manual

Jumbo frames will be enabled after reset

5.7.20 port storm-control broadcast enable

The port storm-control broadcast enable interface configuration command enables broadcast storm control. To disable
broadcast storm control, use the no form of this command.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate interface configuration command, to set the maximum allowable broadcast rate.
Multicast can be counted as part of the "storm" frames if the port storm-control include-multicast global configuration
command is already executed.
Example
The following example enables broadcast storm control on port e5.
Console(config)# interface ethernet e5
Console(config-if)# port storm-control broadcast enable

5.7.21 port storm-control broadcast rate

The port storm-control broadcast rate interface configuration command configures the maximum broadcast rate. Use the no
form of this command to configure the default value.
port storm-control broadcast rate rate
no port storm-control broadcast rate
rate—Maximum of kilobytes per second of broadcast and multicast traffic on a port. (Rate: 70 - 100000)
User's Manual of WGSD-1022/WGSD-8000
- 216 –