Show Interfaces Status - Planet WGSD-1022 User Manual

Port Type
-------- ------------
e1 100M-Copper Full
e2 100M-Copper Full
e3 100M-Copper Full
e4 100M-Copper Full
e5 100M-Copper Full
e6 100M-Copper Full
e7 100M-Copper Full
e8 100M-Copper Full
g1 1G-Combo-C Full
g2 1G-Combo-C Full
Ch Type Speed Neg control
-------- ------- ----- --------
ch1 -- --
ch2 -- --
ch3 -- --
ch4 -- --
ch5 -- --
ch6 -- --
ch7 -- --
ch8 -- --
The displayed port configuration information includes the following:
Port—The port number.
Port Type—The port designated IEEE shorthand identifier. For example 1000Base-T refers to 1000 Mbps baseband
signaling inluding both Tx and Rx transmissions.
Duplex—Displays the port Duplex status.
Speed—Refers to the port speed.
Neg—Describes the Auto-negotiation status.
Flow Control—Displays the Flow Control status.
Back Pressure—Displays the Back Pressure status.
MDIX Mode—Displays the Auto-crossover status.
Admin State—Displays whether the port is enabled or disabled.

5.7.15 show interfaces status

The show interfaces status user EXEC command displays the status for all configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number | out-of-band-eth oob-interface]
Interface — A valid Ethernet port.
Duplex Speed Neg
------ ----- --------
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
1000 Enabled Off
1000 Enabled Off
Flow Admin
State
------- -----
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up
Flow Admin Back
control State Pressure Mode
------- ----- -------- ----
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
- 210 –
User's Manual of WGSD-1022/WGSD-8000
Mdix