Duplex; Flow-Control - Planet WGSW-28040 Command Manual

This example shows how to show current interface link speed
Switch# show interfaces gi1-2 status
Port Name Status Vlan Duplex Speed Type
gi1 connected 1 a-full a-100M Copper
gi2 connected 1 a-full a-100M Copper

4.20.3 duplex

Command:
duplex (auto | full | half)
Parameter:
auto
full
half
Default:
Default port duplex is auto.
Mode:
Interface Configuration
Usage Guide:
Use "duplex" command to change port duplex configuration.
Example:
This example shows how to add a login authentication list to authenticate with order tacacs+, radius, local.
Switch(config)# aaa authentication login test1 tacacs+ radius local

4.20.4 flow-control

Command:
flow-control (off | on)
Specify port duplex to auto negotiation.
Specify port duplex to force full duplex.
Specify port duplex to force half duplex.
Command Guide of WGSW-28040
249