Table of Contents
Advertisement
5. COMMAND LINE INTERFACE
5.1 Accessing the CLI
When accessing the management interface for the switch over a direct connection to the server's console port, or via a Telnet
connection, the switch can be managed by entering command keywords and parameters at the prompt. Using the switch's
command-line interface (CLI) is very similar to entering commands on a UNIX system.
This chapter describes how to use the Command Line Interface (CLI).
The following screen based on GS-4210-24UP4C will be the same as that of GS-4210-8UP2S and
GS-4210-16UP4C.
Logon to the Console
Once the terminal is connected to the device, power on the GS-4210 802.3BT PoE++ Series and the terminal will run self
testing procedures.
Then, the following message asks to login user name and password. The factory default user name and password are shown as
follows and the login screen in
Username: admin
Password: admin
On"Username" &"Password"prompt, enter "admin".
1.
2.
The user can now enter commands to manage the GS-4210 802.3BT PoE++ Series. For a detailed description of the
commands, please refer to the following chapters.
1.
For security reason, please change and memorize the new password after this first setup.
2.
Only accept command in lowercase letter under console interface.
User's Manual of GS-4210-8UP2S/GS-4210-16UP4C/GS-4210-24UP4C
Figure
5-1
appears.
Figure 5-1 GS-4210 802.3BT PoE++ Series Console Login Screen
346
Advertisement
Table of Contents
