Monitor Outputs Continued; Talkback In/Out (Tb Out, Tb In); Mults - Euphonix CS3000 Operation Manual

Monitor Outputs
Continued...
Talkback In/Out
(TB Out, TB In)

Mults

Euphonix CS3000/2000 Operation Manual
If you select I/C in all three monitor menus you can select between three
different monitors in the control room. Only one feed will be active at any one
time. You also have the choice of sending the AFL/PFL signal to any combina-
tion of the three monitors.
The console provides switching to allow each monitor output to be fed in
stereo, mono (sum of left and right), left channel only (both outputs fed from
the left channel of the source) or right channel only. This function allows you
to use one (or more) of your monitor outputs to obtain a mono output from a
stereo mix.
Jack 43 gives you a +4dB feed from the Talkback signal. This is post the
Talkback Selector switch (see Section 4: Tutorial), so it can source a combina-
tion of the external patchable input, the Talkback mic and the Oscillator. This is
useful as a feed to an external talkback system, or if you need to patch tone to
an external device.
The Talkback section allows for 3 sources: Talkback Mic, Internal Oscillator,
and a patched mono external input, such as a pink noise generator. All or any
of these can be routed to the AUX, Multitrack, and Main Stereo Output buses
when the Talkback ON key is pressed in the Master section of the Mix Control-
ler.
Two mults are provided. Jacks 45-48 are paralleled together as are jacks 93 to
96.
Section 5: The Patchbay
5 - 13