Dynamics Factory Presets (Modes) - Euphonix CS3000 Operation Manual

Dynamics Factory
Presets (Modes)
Dynamics Access Menu
31D1->
Shows to which channel
the dynamics preset will be
recalled, and also to which
dynamics processor in that
channel (Dyn1 or Dyn2)
Euphonix CS3000/2000 Operation Manual
The Dynamics Factory Preset Library and menu are similar to the Snapshot list
and menu. The first factory preset is the default mode for the processors
(Gate/Comp). You can recall factory settings and put individual ES108A
processors in different modes, and store the settings into your console snap-
shots.
Factory Preset Library (Modes)
Provided in ES108A firmware
To get to the factory presets, from the Dynamics Access menu, press [F2]
(down arrows) and then [F1] (Preset):
Gate Dpth
F1 F2 F3
Preset Menu
31D1
F1
Shows last Toggles between
recalled factory presets and
factory user presets
preset
Factory preset information is permanently located in the firmware. User
presets cannot be stored in the Factory Preset list, and trying to store in these
locations will generate an error message in the SmartDisplay.
-> >- Preset
F4 F1
1f RCL
F2 F3
Shows that preset
recall (RCL) is enabled
Section 9: Dynamics
Assign Calib
F2 F3 F4
2f
F4
Recalls the
selected
factory
preset
SpinKnob scrolls
through presets
on the screen.
+
Bus
-
DIR
*
ST
DSC [+]/[–] keys
recall presets as
they are scrolled
9 - 39