The Mix Snapshot; Creating A New Mix; Naming A New Mix; New Mix Dialog - Euphonix CS3000 Operation Manual

The Mix Snapshot

Creating a New Mix

Main Menu
Setup
F1
System Menu
File
F1

Naming a New Mix

New Mix Dialog

Dialog box warns you that if
you create a new mix, you
will lose any unsaved mixes.
Name mix, press [Return].
Euphonix CS3000/2000 Operation Manual
Creating a new mix also creates a "Mix SnapShot". Before creating a new mix
it is best to establish a rough balance so that when the Mix SnapShot is taken
it represents a starting point for the mix. The Mix SnapShot is separate from
the 50 console snapshots and is only used by the mix.
When you have a title loaded and have established a basic, manual mix,
create a new mix file. From the Mix menu, press [F1] to create a new mix:
Snap System Grps
F2 F3 F4
F-Link GPI MIDI
F2 F3 F4
New Mix
F1
Using the QWERTY keyboard, name the mix then press [Return]. If you choose
not to name the mix at this time, press [Return] and the system will enter
"MIX01" as the name of the first mix. Pressing [Return] on the keyboard is the
same as pressing [F3] on the SmartDisplay. Press [F4] to abort new mix.
The only data in the mix so far is the Mix SnapShot (static console settings).
Every setting on the board including ES108A Dynamics processors, expanded
aux sends and multi-format panning buses are saved as part of the Mix
SnapShot.
Disk Project
F1
New? Load?
F1
? Yes [No]
F2 F3 F4
Section 7: Automation
Title Mix
F2 F3 F4
Save? Utils
F2 F3 F4
File Menu
Mix Menu
7 - 5