Title Comments; What's In A Title; Save Title; Load Title - Euphonix CS3000 Operation Manual

Title Comments

What's in a Title?

Save Title

Load Title

Main Menu
Setup
F1
System Menu
File
F1
Euphonix CS3000/2000 Operation Manual
You can enter comments about a particular title by pressing the Tab key when
the title has been highlighted. When in the Comments field, simply type in
your comments and press Tab again to exit. To move between titles when in
the Title list, use the SpinKnob or the DSC [+]/[–] keys.
Now that you have a title you can start to work and save what you do. When a
new title is created, the current set of snapshots in the console gets saved to
the new title's SnapShot list.
Every title contains:
50 Snapshots - Up to 50 snapshots are stored with each title. The Snapshot
list is shown on the right-hand side of the screen display.
Audio Cube - Bus allocations, bus names, bus linking and inserts, and I/O
switch settings.
Dynamics - Assignments of CS3000/2000 channels to ES108A channels.
MX464 Master Expander - GPI relay assignments.
Mixes - Up to 200 mixes can be stored within a title.
Cues - Up to 999 cue points can be used to place and view events.
Macros - These function keys allow a single button press to carry out a
number of factory-programmed actions.
Title Setup - Time display type, timecode type, Head & Tail times, etc.
Comments - User comments pertaining to the title.
At any time you can save the current title by going to the Title menu and
pressing [F3] below the SmartDisplay. This saves anything in the title that you
may have changed since the last save such as snapshots, comments, cues,
etc. When you save a title that has mixes and you have made changes to the
mixes, a prompt will come up on the screen asking if you would like to save
the changes. If you reply "yes", changes are saved to the mix, its SnapShots
and automation templates. The next time you load the title, it will load the last
mix and bring back that mix's snapshot and template.
The diagram below shows how to get to the Title menu from the top-level
Main menu. Press [F3] (System), [F1] (File), [F3] (Title) and then [F2] (Load?) to
load a title:
Snap System Grps
F2 F3 F4
F-Link GPI MIDI
F2 F3 F4
Section 2: Getting Started
Disk Project Title
F1 F2 F3
New? Load? Save?
F1 F2 F3
File Menu
Mix
F4
Title Menu
Utils
F4
2 - 13