Zoom Factor; Trim Mode - Euphonix CS3000 Operation Manual

Section 7: Automation

Zoom Factor

With zoom activated,
window will display 25 secs.
at a time.

Trim Mode

7 - 14
From the Pass Control Screen Setup menu, press [F3] (Show):
Zoom Full
F1 F2
Set:EQ1 LG / lG / hG / HG
F1 F2
In this menu, each row can be configured individually or all four rows can be
configured simultaneously by recalling "Sets".
In Set mode (Set:EQ1 in our example), [F3]/[F4], the [+]/[–] keys and the
SpinKnob select the set for the four rows. Remember, a "Set" is a preset that
configures all four rows . Press [F1] to toggle between Row and Set modes:
Row 1:
In Row mode, [F2] selects the row to be configured. [F3]/[F4], the [+]/[–] keys
and the SpinKnob allow selection of the parameter to be viewed in the row.
[F4] (ZFac) sets the zoom factor of the Pass Control window when Zoom is
active. Press the [F4] (ZFac) key:
ZFac : 25
Pressing [F1] or [F2] decrements or increments the displayed numeric value
respectively. The SpinKnob may also be used to adjust the numeric value. [F3]
sets the unit modifier for the menu's numeric value. Available choices are
Seconds, Minutes and Percent.
Up to this point we have been writing automation in ABSolute mode. The
absolute fader position was written to automation. Trim is used to change the
overall gain of the signal and still retain any mix moves previously recorded.
Fader moves in Trim mode are relative to the original automation moves.
Show ZFac
F3 F4
F3 F4
EQ1
F1 F2 F3
Seconds
F1 F2 F3
Euphonix CS3000/2000 Operation Manual
lG
F4
F4