Locating To Start (Lts) Function; Fader Names - Euphonix CS3000 Operation Manual

Section 4: Tutorial
Locating To Start
(LTS) Function

Fader Names

4 - 70
displayed in the timecode window of the Status Bar. If none of these timecode
locations coincides with your desired start or end points, input a timecode
value from the numeric keypad and press [Enter].
With LTS (Locate To Start) enabled, pressing the [Cycle] key will locate the
MMC device or the VTM to the Cycle Start point and start/continue to cycle.
With LTS disabled, pressing the [Cycle] key will put MMC device or the VTM
into Play mode and start/continue to cycle from the present location. The LTS
function can be toggled on and off from the Cycle menu (shown above) by
pressing [F4].
There is a window which can be used to associate each fader with a name.
The list is accessed by pressing [F2] on the QWERTY keyboard. The currently
active fader will be available for naming. The user can name other faders by
pressing the appropriate block attention key or by pressing the appropriate
channel select and upper/lower fader elect keys on the DSC.
As the user enters the name for the fader, the name is also displayed in the
status bar:
Whenever this fader is the active fader, its name will appear in the status bar.
The track list is saved with the title. The fader names also appear above each
channel on the Mix Controller if your console is outfitted with the Euphonix
CleaR displays option.
Euphonix CS3000/2000 Operation Manual