Professional control surface artist series (52 pages)
Summary of Contents for Euphonix System 5 Control Surface/Frame
Page 1
Tel: (650)855-0400 Fax: (650) 855-0410 Web Page: www.euphonix.com In the interest of continued product development, Euphonix reserves the right to make improvements in this manual and the product it describes at any time, without notice or obligation. System 5, S-5, PatchNet, eMix, EuCon, R-1, Studio Hub, , Digital Studio Controller, DSC, CleaR, GainBall,...
Servicing – Do not attempt to service the Control Modules beyond those means described in this operation manual. All other servicing should be referred to the Euphonix Tech Support department. Fuse replacement – To prevent electric shock and avoid risk of fire, replace fuse only with the same type and rating.
The Control Surface communicates with the System 5 component assemblies via Ethernet network connections. Control signals are transmitted to the Euphonix EH224 EuCon Hub and distributed to the various System 5 component assemblies. No audio passes through the Control Surface.
The Expansion Port on the module is a DB25 female connector. A DB25 male cable needs to be built to interface to this port (pictured below). The pinout has been configured for easy interface to the Euphonix GP132 box, and is as shown on the following page:...