Extreme Networks ExtremeWare Command Reference Manual page 2393

— "class1": class 1 device
— "class2": class 2 device
— "class3": class 3 device
— "class4": class 4 device
• Connect History—Displays the connection order of the port from the connection history (if one
exists):
— 0: No connection history exists or the port is not in the history list.
— 1 – 32: There is a connection history and the port is in the history list.
• Volts—Displays the measured voltage. A value from 0 – 2V is valid for ports that are in a searching
or discovered state.
• Curr—Displays the measure current in milli Amps (mA).
• Res—Displays the measured resistance in kilo Ohms (Kohms). A value greater than 100 Kohms
indicates an empty port.
• Power—Displays the measured power in watts.
• Fault—Displays the fault value:
— 0: No fault
— 1: Over voltage
— 2: Over voltage spike
— 3: Peak over current
— 4: Overload
— 8: Discovery resistance failed
— 9: Class violation
— 10: Disconnect
— 11: Discovery resistance, A2D fail
— 12: Classify, A2D fail
— 13: Sample A2D fail
— 14: Device fault, A2D fail
The detail command lists all inline power information for the selected ports. Detail output displays the
following information:
• Configured Admin State
• Inline Power State
• MIB Detect Status
• Label
• Violation Precedence
• Operator Limit
• Detection
• Reserved Power
• Inline Type
• Connect Order
ExtremeWare 7.7 Command Reference Guide
show inline-power info show inline-power info port
2393