Configure Mpls Tls-Tunnel Lsp - Extreme Networks ExtremeWare Command Reference Manual

configure mpls tls-tunnel lsp

configure mpls tls-tunnel <tunnel_name> [add | delete] lsp <lsp_name>
Description
Deletes a VPLS VC-LSP service connectivity health-check.
Syntax Description
tunnel_name
add
delete
lsp_name
Default
N/A.
Usage Guidelines
This command configures additional LSPs for a TLS tunnel. The add keyword may be used to add up
to four RSVP-TE LSPs to the TLS tunnel specified by tunnel_name. TLS traffic across the TLS tunnel is
aggregated across all configured LSPs. LSP traffic aggregation is described in Equal-cost Multipath LSP
Support on page 3. The delete keyword will remove the LSP specified by the lsp_name parameter from
the VC-LSP aggregation list. If all the LSPs are deleted, the VC-LSP will attempt to use the best-routed
path LSP, if one exists. If no LSPs exist to the TLS tunnel endpoint, TLS tunnel connectivity to the
endpoint IP address is lost.
Example
None
History
This command was first available in an ExtremeWare 7.3.0.
Platform Availability
This command is available on the BlackDiamond switch only.
ExtremeWare 7.7 Command Reference Guide
Refers to the TLS tunnel.
Allows addition of up to 4 RSVP-TE LSPs to the TLS tunnel.
Removes the specified LSP.
Specifies the LSP.
configure mpls tls-tunnel lsp
2471