Configure Mpls Rsvp-Te Add Profile - Extreme Networks ExtremeWare Command Reference Manual

configure mpls rsvp-te add profile

configure mpls rsvp-te profile <profile_name> {bandwidth <bps>}
{setup-priority <priority>} {hold-priority <priority>} {retry-timeout
<seconds>} {hop-count <number>} {ping-interval <seconds>} {metric [<metric>
| igp-tracking} {record [enabled | disabled]} {mtu <number>}
Description
Adds an RSVP-TE profile.
Syntax Description
profile_name
bandwidth
setup-priority
hold-priority
retry-timeout
ping-interval
metric
record
mtu
Default
N/A
Usage Guidelines
A profile is a set of attributes that are applied to the LSP when the LSP is configured using the
configure mpls rsvp-te add lsp
but can be applied to any configured LSP. The profile name for the default profile is default. The default
profile parameter values are initially set to their respective default values. The maximum number of
configurable profiles is 255 (one of which is reserved for the default profile).
The
bandwidth
bps value is valid. Optionally, you can append the characters, k for kilobits, m for megabits, or g for
gigabits, to the bps value to specify the unit of measure. If the k, m, or g, character is omitted, the unit
of measure is assumed to be kilobits. The default bandwidth bps value is zero, which indicates that the
QoS for the LSP is best effort. ExtremeWare does not support bandwidth reservation.
The
setup-priority
path set up, if the requested bandwidth cannot be reserved through the LSR, the
parameter is compared to the
need to be preempted to allow a higher priority LSP to be established. Lower numerical values
represent higher priorities. The
ExtremeWare 7.7 Command Reference Guide
Specifies the profile name.
Specifies the reserved bandwidth for the LSP.
A value that is compared to the hold-priority of existing LSPs to determine if any of the existing
LSPs need to be preempted to allow a higher priority LSP to be established.
A value that is compared to the setup-priority of existing LSPs to determine if any of the existing
LSPs need to be preempted to allow a higher priority LSP to be established.
Specifies the maximum number of seconds the switch allows for LSP setup.
Specifies how frequently an ICMP echo request is transmitted to the egress LSR IP address on
the established LSP.
Specifies a route metric used to determine if an established RSVP-TE LSP will actually be used
to send data.
Specifies hop-by-hop path recording.
Specifies the MTU value transport payload packet (customer packet).
command. A default profile is provided which cannot be deleted,
parameter specifies the desired reserved bandwidth for the LSP. Any positive integer
and
hold-priority
hold-priority
setup-priority
are optional parameters indicating the LSP priority. During
of existing LSPs to determine if any of the existing LSPs
range is 0 to 7 and the default value is 7. The
configure mpls rsvp-te add profile
setup-priority
2535