Configure Mpls Rsvp-Te Add Path - Extreme Networks ExtremeWare Command Reference Manual

configure mpls rsvp-te add path

configure mpls rsvp-te add path <path_name> [<ipaddress> | <host_name>]
{from <local_endpoint_vlan>}
Description
Adds a path to an RSVT-TE LSP.
Syntax Description
path_name
ipaddress
hostname
local_endpoint_value
Default
N/A
Usage Guidelines
The
<path_name
parameter is a character string that is to used to identify the path within the switch. The <
string must begin with an alphabetic character, and may contain up to 31 additional alphanumeric
characters. Each
If the
<host_name>
> can first be resolved to an IP address. Alternate routed paths to the same IP destination
<host_name
may be configured by adding additional <
<host_name>
The RSVP-TE path is not signaled until an LSP is added with the specified
route objects are configured, the path will follow the best-routed path to the configured
(or IP address obtained from DNS name resolution). Optionally, the
specify the
<local_endpoint_vlan>
configurable paths is 255.
Example
The following command adds a path to 76.42.10.1 called paththroughdenver:
configure mpls rsvp-te add path paththroughdenver 76.42.10.1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
ExtremeWare 7.7 Command Reference Guide
Specifies the path name.
Specifies the IP address.
Specifies the hostname.
Specifies the local endpoint from which the path is signaled.
> and or <
<ipaddress>
represents a routed path to a single IP destination.
<path_name>
is specified, the DNS client on the switch must be configured so that the
as the path endpoint.
from which the path is signaled. The maximum number of
must be specified for the path. The
host_name>
and specifying the same
path_names>
configure mpls rsvp-te add path
<path_name>
path_name>
<ipaddress>
. If no explicit
<path_name>
<ipaddress>
keyword can be used to
from
or
2533