Show Interfaces Status - Dell PowerEdge M I/O Aggregator Reference Manual

Command Modes
Command
History
Example
Related
Commands

show interfaces status

Syntax
Parameters
Defaults
Command Modes
150 | Interfaces
EXEC
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
Figure 11-25. show interfaces status Command Example
FTOS#show interfaces stack-unit 0
TenGigabitEthernet 0/1 is down, line protocol is down
Hardware is DellForce10Eth, address is 00:1e:c9:f1:00:05
Current address is 00:1e:c9:f1:00:05
Server Port AdminState is Down
Pluggable media not present
Interface index is 34148609
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :tenG130001ec9f10005
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 5d5h24m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 5d5h23m
!-------------output truncated ----------------!
show diag
Displays a summary of interface information or specify a stack unit and interface to display status
information for that specific interface only.
show interfaces [ interface | stack-unit unit-number ] status
interface
none
EXEC
EXEC Privilege
0 packets/sec, 0.00% of line-rate
0 packets/sec, 0.00% of line-rate
Displays data plane and management plane input/output statistics.
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.