Dell PowerEdge M I/O Aggregator Reference Manual page 75

ssh-peer-stack-unit
Open an SSH connection to the peer stack-unit.
ssh-peer-stack-unit [-l username]
Syntax
Parameters
-l username
Defaults
Not configured.
Command Modes EXEC Privilege
Command
Version 8.3.17.0
History
telnet
Connect through Telnet to a server. The Telnet client and server in FTOS supports IPv4 connections.
You can establish a Telnet session directly to the router, or a connection can be initiated from the router.
Syntax
telnet { host | ip-address } [ /source-interface ]
Parameters
host
ip-address
/source-interface
Defaults Not configured.
Command Modes
EXEC
EXEC Privilege
Command
Version 8.3.17.0
History
Usage
Telnet to link-local addresses is not supported.
Information
(OPTIONAL) Enter the keyword -l followed by your username.
Default: The username associated with the terminal.
Supported on M I/O Aggregator
Enter the name of a server.
Enter the IPv4 address in dotted decimal format of the server.
(OPTIONAL) Enter the keywords
information to include the interface's IP address.
Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
• For a VLAN interface, enter the keyword
to 4094.
Supported on M I/O Aggregator
/source-interface
followed by the interface
TenGigabitEthernet
vlan
followed by a number from 1
Control and Monitoring | 73