Dell PowerEdge M I/O Aggregator Reference Manual page 93

Command
Version 8.3.17.4
History
Version 8.3.17.0
Figure 7-1. Disable DCB Command Example
Example 1
FTOS#show dcb stack-unit 0 port-set 0
stack-unit 0 port-set 0
DCB Status :
PFC Port Count :
PFC Queue Count :
FTOS#
FTOS#conf
FTOS(conf)#dcb enable ?
on-next-reload
FTOS(conf)#no dcb enable on-next-reload
FTOS(conf)#00:03:11: %STKUNIT0-M:CP %DIFFSERV-6-DCB_DISABLE_CFG_ON_RELOAD:
Global DCB will be disabled on subsequent reload, All reserved PFC buffers will
be deleted from each stack unit. For the pfc-buffering change to take effect,
please save the config and reload the system.
FTOS(conf)#end
FTOS#00:03:23: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from
FTOS#write memory
00:03:28: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to
startup-config in flash by default
FTOS#reload
Proceed with reload [confirm yes/no]: yes
00:04:13: %STKUNIT0-M:CP %CHMGR-5-RELOAD: User request to reload the chassis
syncing disks... done
unmounting file systems...
unmounting /f10/flash (/dev/ld0e)...
unmounting /usr (mfs:31)...
unmounting /lib (mfs:23)...
unmounting /f10 (mfs:20)...
unmounting /tmp (mfs:15)...
unmounting /kern (kernfs)...
unmounting / (/dev/md0a)... done
rebooting...
FTOS#
FTOS#show dcb stack-unit 0 port-set 0
stack-unit 0 port-set 0
DCB Status : Disabled
PFC Port Count :
PFC Queue Count :
FTOS#
Added auto-detect parameter.
Supported on M I/O Aggregator
Enabled
56 (current), 0 (configured)
2 (current), 0 (configured)
Apply DCB configs on subsequent reload
0 (current), 0 (configured)
0 (current), 0 (configured)
console
Data Center Bridging | 91