Dell PowerEdge M I/O Aggregator Reference Manual page 74

Example 2
show util-threshold cpu
Syntax
Command Modes
Command
History
Usage
Information
show util-threshold memory
Syntax
Command Modes
Command
History
Usage
Information
72 | Control and Monitoring
Figure 5-32. show uplink detail Command Example
FTOS#show uplink detail
---------------- show uplink detail ---------------------
TenGigabitEthernet 0/41 is up, line protocol is down
Hardware is DellForce10Eth, address is 00:1e:c9:f1:00:99
Current address is 00:1e:c9:f1:00:99
Port is not prsent
Pluggable media not present
Interface index is 44634881
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :tenG170001ec9f10099
MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d19h53m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
--More--
Displays the set CPU utilization threshold values.
show util-threshold cpu
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
This command displays all CPU utilization thresholds of the management, standby, and stack-units.
Displays the set memory utilization threshold values.
show util-threshold memory
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
This command displays all memory utilization thresholds of the management, standby, and stack-units.