Show Interfaces Description - Dell PowerEdge M I/O Aggregator Reference Manual

Example

show interfaces description

Syntax
Parameters
Command Modes
Command
History
146 | Interfaces
Figure 11-21. show interfaces configured Command Example
FTOS#show interfaces configured
TenGigabitEthernet 1/1 is up, line protocol is down(error-disabled[UFD])
Hardware is DellForce10Eth, address is 00:01:e8:00:ab:01
Current address is 00:01:e8:00:ab:01
Server Port AdminState is Down
Pluggable media not present
Interface index is 67703553
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :tenG2580001e800ab01
MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 05:15:07
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 05:14:12
TenGigabitEthernet 1/2 is up, line protocol is down(error-disabled[UFD])
FTOS#
Displays the descriptions configured on the interface.
show interfaces [ interface ] description
interface Enter one of the following keywords and slot/port or number information:
• For the management interface on the stack unit enter the keyword
ManagementEthernet
the port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
the slot/port information.
• For VLAN interfaces, enter the keyword
EXEC
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
0 packets/sec, 0.00% of line-rate
0 packets/sec, 0.00% of line-rate
followed by the slot/port information. The slot range is 0-0 and
TenGigabitEthernet
vlan
followed by a number from 1 to 4094.
followed by