Terminal Monitor - Dell PowerEdge M I/O Aggregator Reference Manual

Command
Version 8.3.17.0
History
Usage This command enables XML input mode where you can either cut and paste XML requests or enter the
Information
XML requests line-by-line.

terminal monitor

Configure the FTOS to display messages on the monitor/terminal.
terminal monitor
Syntax
To return to default settings, use the no terminal monitor command.
Defaults
Disabled.
Command Modes EXEC
EXEC Privilege
Command
Version 8.3.17.0
History
traceroute
View the packet path to a specific device.
Syntax traceroute { host | ip-address }
Parameters
host
ip-address
Defaults
Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434
Command Modes
EXEC
EXEC Privilege
Command
Version 8.3.17.0
History
Usage When you enter the traceroute command without specifying an IP address (Extended Traceroute), you
Information
are prompted for a target and source IP address, timeout in seconds (default is 5), a probe count
(default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is
33434). To keep the default setting for those parameters, press the ENTER key.
Supported on M I/O Aggregator
Supported on M I/O Aggregator
Enter the name of device.
Enter the IP address of the device in dotted decimal format.
Supported on M I/O Aggregator
Control and Monitoring | 75