Dell PowerEdge M I/O Aggregator Reference Manual page 198

Command Modes
Command
History
Example
Related
Commands
show running-config monitor session
Syntax
Parameters
Defaults
Command Modes
Command
History
Example
Usage
Information
196 | Port Monitoring
EXEC
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
Figure 17-3.
show monitor session Command Example
FTOS#show monitor session 5
SessionID Source
--------- ------
5 Te 0/4
FTOS#
monitor session
Displays the running configuration of all monitor sessions or a specific session.
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use just the
monitor session command.
session-ID
none
EXEC
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
Figure 17-4. show running-config monitor session Command Example
FTOS#show run monitor session
!
monitor session 5
source TenGigabitEthernet 0/4 destination TenGigabitEthernet 0/43 direction rx
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/42 direction both
FTOS#
FTOS#show run monitor session 20
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/42 direction both
FTOS#
The monitoring command is saved in the running configuration at the Monitor Session mode level and
can be restored after a chassis reload.
Destination
-----------
Te 0/43
Creates a session for monitoring.
(OPTIONAL) Enter a session identification number.
Range: 0 to 65535
Direction Mode
--------- ----
rx interface
show running-config
Type
----
Port-based