Dell PowerEdge M I/O Aggregator Reference Manual page 43

debug cpu-traffic-stats
Enable the collection of CPU traffic statistics.
debug cpu-traffic-stats
Syntax
Defaults Disabled
Command Modes
EXEC Privilege
Command
Version 8.3.17.0
History
Usage
This command enables (and disables) the collection of CPU traffic statistics from the time this
Information
command is executed (not from system boot). However, excessive traffic received by a CPU
automatically triggers (turns on) the collection of CPU traffic statistics. Use the
lock
If excessive traffic is received by CPU, traffic is rate controlled
Related
show configuration
Commands
lock
debug ifm trace-flags
Turn on the IFM internal trace-flags.
Syntax debug ifm trace-flags trace-flags
Disable this command using the no debug ifm trace-flags command.
Parameters
trace-flag
Defaults None
Command Modes
EXEC Privilege
Command
Version 8.3.17.0
History
Usage Disable this command using the no debug ifm trace-flags command.
Information
Supported on M I/O Aggregator
to view the traffic statistics.
Note:
This command must be enabled before the
. Dell
traffic statistics
cpu-traffic-stats) after troubleshooting is complete
Displays the cpu traffic statistics
Enter a hexadecimal number representing the trace-flag.
Supported on M I/O Aggregator
Note:
Use this command only when you are working directly with a technical support
representative to troubleshoot a problem. Do not use this command unless a technical support
representative instructs you to do so.
Force10 recommends disabling debugging ( no debug
show configuration
show configuration lock command displays
.
Control and Monitoring | 41