Dell PowerEdge M I/O Aggregator Reference Manual page 94

Example 2
92 | Data Center Bridging
Figure 7-2. Enable DCB Command Example
FTOS#show dcb stack-unit 0 port-set 0
stack-unit 0 port-set 0
DCB Status : Disabled
PFC Port Count : 0
PFC Queue Count : 0
FTOS#
FTOS#
FTOS#conf
FTOS(conf)#dcb enable on-next-reload
FTOS(conf)#00:02:35: %STKUNIT0-M:CP %DIFFSERV-6-DCB_ENABLE_CFG_ON_RELOAD:
Global DCB will be enabled on subsequent reload, PFC buffers will be reserved
for all pfc ports and max loss less queues supported for each stack unit. For
the pfc-buffering change to take effect, please save the config and reload the
system.
FTOS(conf)#end
FTOS#00:02:38: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from
FTOS#write memory
00:02:41: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to
startup-config in flash by default
FTOS#reload
Proceed with reload [confirm yes/no]: yes
syncing disks... done
unmounting file systems...
unmounting /f10/flash (/dev/ld0e)...
unmounting /usr (mfs:31)...
unmounting /lib (mfs:23)...
unmounting /f10 (mfs:20)...
unmounting /tmp (mfs:15)...
unmounting /kern (kernfs)...
unmounting / (/dev/md0a)... done
rebooting...
FTOS#show dcb stack-unit 0 port-set 0
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2
FTOS#
(current), 0 (configured)
(current), 0 (configured)
(current), 2 (configured)
console