Dell PowerEdge M I/O Aggregator Reference Manual page 50

Defaults
Command Modes
Command
History
Usage
Information
reload
Syntax
Command Modes
Command
History
Usage
Information
Related
Commands
48 | Control and Monitoring
sweep-interval Enter the incremental value for sweep size.
1-15308 seconds
ointerface
Enter the outgoing interface for multicast packets.
•
•
•
See parameters above.
EXEC
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
When you enter the ping command without specifying an IP address (Extended Ping), you are
prompted for a target IP address, a repeat count, a datagram size (up to 1500 bytes), a timeout in
seconds, and for Extended Commands. For information on the ICMP message codes that return from a
ping command, refer to Chapter 26, Internet Control Message Protocol (ICMP) Message
Figure 5-3. ping (IPv4) Command Example
FTOS#ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds:
Reply to request 1 from 172.31.1.208
Reply to request 1 from 172.31.1.216
Reply to request 1 from 172.31.1.205
:
:
Reply to request 5 from 172.31.1.209
Reply to request 5 from 172.31.1.66
Reply to request 5 from 172.31.1.87
FTOS#
Reboot FTOS.
reload
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
If there is a change in the configuration, FTOS prompts you to save the new configuration. Or you can
save your running configuration with the copy running-config command.
s
reset stack-unit Resets any designated stack member except the management unit.
Enter the IP address in A.B.C.D format
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
For a VLAN interface, enter the keyword
4094.
0 ms
0 ms
16 ms
0 ms
0 ms
0 ms
TenGigabitEthernet
vlan
followed by a number from 1 to
Types.