Dell PowerEdge M I/O Aggregator Reference Manual page 136

Example
Example
Example
FTOS(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 – 2,
Vlan 2 – 100 , Port 1 – 25
FTOS(conf-if-range)# no shutdown
FTOS(conf-if-range)#
Related
Commands
interface range macro (define)
Syntax
Parameters
134 | Interfaces
Figure 11-6 is an example of a single range bulk configuration.
Figure 11-6. Single Range Bulk Configuration
FTOS(conf)# interface range tengigabitethernet 5/1 - 23
FTOS(conf-if-range)# no shutdown
FTOS(conf-if-range)#
Figure 11-7 shows how to use commas to add different interface types to the range enabling all Ten
Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and
1/2.
Figure 11-7. Multiple Range Bulk Configuration Gigabit Ethernet and Ten Gigabit
Ethernet
FTOS(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2
FTOS(conf-if-range)# no shutdown
FTOS(conf-if-range)#
Figure 11-8 shows how to use commas to add VLAN and port-channel interfaces to the range.
Figure 11-8. Multiple Range Bulk Configuration with VLAN and port channel
show config (from INTERFACE
RANGE mode)
show interfaces status
interface range macro (define)
Defines a macro for an interface range and then saves the macro in the running configuration.
define interface range macro name interface , interface , ...
name
...
interface , interface ,
Shows the bulk configuration interfaces.
Displays a summary of interface information.
Defines a macro for an interface-range.
Enter up to 16 characters for the macro name.
interface
Enter the keyword (see below) and one of the interfaces slot/port,
port-channel or VLAN numbers. Select the range of interfaces for bulk
configuration. You can enter up to six comma separated ranges—spaces are
not required between the commas. Comma-separated ranges can include
VLANs, port-channels and physical interfaces.
Slot/Port information must contain a space before and after the dash. For
interface range tengigabitethernet 0/1 - 5
example,
interface range tengigabitethernet 0/1-5
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
4094.
is valid;
is not valid.
vlan
followed by a number from 1 to