Dell PowerEdge M I/O Aggregator Reference Manual page 158

shutdown
Syntax
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
speed (for 1000/10000/auto interfaces)
Syntax
Parameters
Defaults
156 | Interfaces
Disable an interface.
shutdown
To activate an interface, enter no shutdown .
The interface is disabled.
INTERFACE
Version 8.3.17.0 Supported on M I/O Aggregator
The show tdr command marks a physical interface as unavailable for traffic. To discover if an interface
is disabled, use the show ip interface
Disabling a VLAN or a port channel causes different behavior. When a VLAN is disabled, the Layer 3
functions within that VLAN are disabled. Layer 2 traffic continues to flow. Entering the
command on a port channel disables all traffic on the port channel and the individual interfaces within
the port channel. To enable a port channel, you must enter
and at least one interface within that port channel.
The show tdr and description
that is a member of a port channel.
vlan tagged
interface vlan
show ip interface
Set the speed for 1000/10000 Base-T Ethernet interfaces. Both sides of a link must be set to the same
speed (1000/10000) or to auto or the link may not come up.
speed { 1000 | 10000 | auto }
To return to the default setting, use the no speed { 1000 | 10000 | auto } command.
1000
Enter the keyword
10000
Enter the keyword
(Auto-negotiation is enabled. See
auto
Enter the keyword
(Auto-negotiation is enabled. See
auto
command. Disabled interfaces are listed as down.
commands are the only commands that you can configure on an interface
Test the condition of copper cables on 100/1000/10G Base-T
modules
.
Creates a VLAN.
Displays the interface routing status. Add the keyword
of interfaces and their status.
1000
to set the interface's speed to 1000 Mb/s.
10000
to set the interface's speed to 10000 Mb/s.
name for more information)
auto
to set the interface to auto-negotiate its speed.
name for more information)
no show tdr on the port channel interface
brief
to display a table
show tdr